Tube packages High Power

Most modern tubes have glass envelopes, but metal, fused quartz (silica), and ceramic have also been used.

High power GS-9B triode transmitting tube with heat sink at bottom.

The first version of the 6L6 used a metal envelope sealed with glass beads, while a glass disk fused to the

Metal cased tubes with "octal" bases

metal was used in later versions. Metal and ceramic are used almost exclusively for power tubes above 2 kW dissipation. The nuvistor was a modern receiving tube using a very small metal and ceramic package.
Tubes have always had their internal elements connected to external circuitry using pins at their base which plug into a socket. After all, tubes needed to be replaced rather frequently unlike modern semiconductor devices which are mostly soldered in place. Subminiature tubes were produced using wire leads rather than sockets, however these were restricted to rather specialized applications. In addition to the connections at the base of the tube, many early triodes connected the grid using a metal cap at the top of the tube; this was done in order to reduce stray capacitance between the grid and the plate leads. Tube caps were also used for the plate (anode) connection, particularly in transmitting tubes and tubes using a very high plate voltage.
High power tubes such as transmitting tubes have packages designed more to enhance heat transfer. In some tubes, the metal envelope is also the anode. The 4CX1000A is an external anode tube of this sort. Air is blown through an array of fins attached to the anode, thus cooling it. Power tubes using this cooling scheme are available up to 150 kW dissipation. Above that level, water or water-vapor cooling are used. The highest-power tube currently available is the Eimac 4CM2500KG, a forced water-cooled power tetrode capable of dissipating 2.5 megawatts. (By comparison, the largest power transistor can only dissipate about 1 kilowatt.)